BYD
Chery
Geely
MGAudi A8L 2022-205 With Four Projector Lens Retrofit Brackets
1. If the light source needs to be retained, use a non-shared negative width pressure line set.
2. It is recommended to change to a 3-inch square lens.
3. You can change the outer position or inner position separately.
Step 1
Outside Low Beam Bracket
Step 2
Inside High Beam Bracket
Step 3
Original Bosch Headlight
Step 3
Remove this electroplating strip
Step 5
There’s a screw here
Step 6
Remove the upper eyebrows
Step 7
Remove the large Black frame
Step 8
Remove the air duct and other components
Step 9
The ball head of the linkage rod at the bottom of the original car is very thin. It is easy to break if you remove it directly. It is recommended to remove the screws at the arrow point and remove the linkage base together.
Step 10
After removing the whole thing, remove the buckle. (If you accidentally break it, please contact our customer service. We also have replacement parts, but they are more expensive.) So be careful when dismantling it.
Step 11
Remove the original car buckle and install it on the outer low beam position
Step 12
Remove the original car buckle and install it on the inner high beam position
Step 13
Install the bracket back to the rear case
Step 14
Just fix the lens in front. Depending on the lens, if there is enough space in front, you can adjust it forward appropriately
Step 15
Get on the car and adjust the light to check if there is any interference.
Step 16
Reinstall the color frame
Step 17
Installation completed
